BarndoVista.
Menu
Browse homes

About The Rafter

The Rafter brings deep amber-brown board-and-batten siding, charcoal trim and a Sahara Tan standing-seam roof to a North Carolina Blue Ridge setting. Its steep main gable covers a 36 x 36 ft home, while a lower two-car garage joins the east side behind the porch line. The 36 x 10 ft covered front porch spans the house front. Inside, the great room combines living, dining and one L-shaped kitchen with no island. The primary bedroom has its own bath and reach-in closet; Bedroom 2 and a second full bath sit beyond the rear hall. A separate flex room has windows on two exterior walls but is not a bedroom. The garage enters through the mudroom / laundry, and mechanical equipment has its own room.

Highlights

  • 36 x 10 ft full-width covered front porch
  • 24 x 26 ft attached two-car garage set behind the porch line
  • Two bedrooms, two full baths and a separate flex room
  • 18 x 19 ft great room with one L-shaped kitchen and no island
  • Mudroom / laundry between the garage and rear hall

Best for: A small household that wants a compact two-bedroom home, a separate flex room and a full front porch.

This plan is in: 2 bedroom barndominium floor plans · Barndominium with garage floor plans · Small barndominium floor plans

In the $149 plan set

See a sample (PDF, dimensions removed)

  • Builder-ready drawing set, dimensioned to the inch
  • Floor plan with every room, door and window located
  • Four exterior elevations
  • Building sections and roof plan
  • Door and window schedules
  • Electrical, smoke and CO placement diagram (locations only, not an electrical design)
  • Foundation outline (layout only, not a foundation design)
  • Editable CAD file (DXF) of the floor plan for your builder or drafter
  • 3-D concept model of the home (.glb file), illustrative only
  • Every picture shown on the home's page, full-size
  • License to build one home

Completed by your local team

  • Structural design and member sizing (beams, footings, framing)
  • Engineering stamps or seals
  • Site-specific engineering, energy or code review
  • Permits or permit approval

Your local builder and, where your project needs one, a licensed engineer or architect complete these for your site and local codes.

Living in The Rafter

Who it suits

The Rafter suits a small household that wants a compact two-bedroom home, a separate flex room and a full front porch.

Room by room

  • Shared room: the 18 x 19 ft great room holds living, dining and one L-shaped kitchen without an island. The kitchen stays on the east and north walls, away from the entry and rear-hall route.
  • Private rooms: the 10 x 13 ft primary bedroom has its own 7 x 6 ft 6 in bath and a 2 ft 6 in x 6 ft 6 in reach-in closet entered from the hall. Bedroom 2 is 11 x 11 ft 6 in; Bath 2 has a tub/shower, toilet and vanity.
  • Flex and service rooms: the separate 10 x 7 ft 6 in flex room has rear and west windows but is not a bedroom. The garage route enters the 8 ft 6 in x 11 ft 6 in mudroom / laundry, and the great room has separate coat and mechanical rooms.

Build notes

  • The 36 x 36 ft house has an 8:12 main gable. A lower 24 x 26 ft garage wing joins its east side, with the garage doors beginning 20 ft behind the porch edge.
  • The full-width front porch is 36 x 10 ft, with 5 posts forming four 9-ft bays.
  • Garage separation, final window products and site details need local professional design. Whole-house mechanical ventilation and kitchen exhaust to outdoors are by your builder.

Finishes and fixtures are illustrative; the plan governs. The floor plan is drawn from the plan set. Areas are approximate and measured to the outside face of exterior walls; porches, garages and shops are listed separately.

Floor plan and specifications

Every room is dimensioned and every door and window carries its size, straight from the plan set.

The Rafter: main floor plan with room dimensions and door and window sizes
Main floor plan. Tap to open full size.
Overall footprint
60 ft wide by 36 ft deep, the buildings' footprint without porches and decks
Stories
1 story
Roof (main house)
  • 8:12 pitch, 18 in overhangs
  • Eave 11'-0", ridge 23'-0"
  • Ridge runs left-to-right, parallel to the front wall
Masses
  • House: 36' x 36', living space, eave 11'-0", ridge 23'-0"
  • Garage: 24' x 26', eave 10'-0", ridge 18'-8"
Porches
  • Craftsman front porch: 36' x 10', 3:12 shed roof continuing the main roof at the eave (pitch break), beam 8 ft 6 in high at the posts, 5 posts
Structure
Drawn for conventional wood (stick) framing; trusses, posts, beams and footings are sized by the builder's engineer. A steel-frame or post-frame version is an adaptation your builder or engineer makes. Member sizes, connections and loads are by your builder's engineer for your site.
Foundation
Typical starting point: monolithic slab-on-grade with a thickened edge (a stem wall where frost depth requires), footings below the local frost line, a footing under every interior bearing line and girder point, and porch-post footings with uplift ties. Slab thickness, footing sizes, reinforcing and anchorage are sized by your engineer for your soil, frost depth and loads; shop and garage slabs are usually heavier than living-area slabs.
Counts
7 windows, 1 exterior door, 2 overhead doors, 5 porch posts

Rooms

RoomSizeArea
Primary bedroom10'-0" x 13'-0"130 sq ft
Primary bath7'-0" x 6'-6"46 sq ft
Primary closet2'-6" x 6'-6"16 sq ft
Bath 210'-0" x 6'-6"65 sq ft
Flex room10'-0" x 7'-6"75 sq ft
Coat closet6'-0" x 4'-0"24 sq ft
Mechanical6'-0" x 5'-0"30 sq ft
Hall front6'-0" x 9'-0"54 sq ft
Hall rear4'-0" x 15'-6"62 sq ft
Great room / kitchen / dining18'-0" x 19'-0"342 sq ft
Rear hall20'-0" x 3'-6"70 sq ft
Bedroom 211'-0" x 11'-6"127 sq ft
Mudroom / laundry8'-6" x 11'-6"98 sq ft
Garage23'-0" x 25'-0"575 sq ft

Doors and windows

Swipe the table sideways to see sill, room and wall.

IDTypeSizeSillRoomWall
W01Window4'-0" x 5'-0"2'-0"Primary bedroomFront
W02Window5'-0" x 5'-0"2'-0"Great room / kitchen / diningFront
W03Window3'-0" x 3'-6"3'-6"Great room / kitchen / diningFront
W04Window4'-0" x 5'-0"2'-0"Flex roomRear
W05Window4'-0" x 5'-0"2'-0"Bedroom 2Rear
W06Window4'-0" x 5'-0"2'-0"Mudroom / laundryRear
W07Window3'-0" x 5'-0"2'-0"Flex roomLeft side
D01Entry door3'-0" x 6'-8"no sillGreat room / kitchen / diningFront
G01Overhead door9'-0" x 8'-0"no sillGarageFront
G02Overhead door9'-0" x 8'-0"no sillGarageFront

Sizes are clear inside dimensions for rooms and rough openings for doors and windows, from the plan set. Roof heights are above the finished floor. The structure and foundation lines are typical starting points: the drawings are not stamped, and your builder's engineer sizes members, footings and anchorage for your site, soil, snow, wind and frost depth.

You might also love

All homes →